Mr. & Mrs Jones

Tiles do not fully line up

Tile bead butted together, should be mitred

Tile bead to corner not flush with the tiles

Extremely rough edge to the door

Door won't close, catches on the bottom

Door keep has not been let into the door lining

Door lining is too near for the width of the wall
Poor paint finish to th woodwork

Rough cut out for the hinges

New wall constructed to the stairs, new wall overhangs the stair string, aprin and newel post but no timber trim have been fitted, leaving the rough edge exposed.
No handle rail fitted

Plasterboard screws are popping the plaster

Wall at the base of the stairs are rough, where the old newel has been built into the new wall.
The corner of thenew wall is not plumb and even

Door fitted upside down

Architrave incomplete, architrave already fitted poorly cut

Rough cut out for door hinge.

Paint on door

Door lining incorrectly constructed out of different width timber

Rough cut out for latch keep.

Ironmongery does not match

Plaster work both side of the door way, poorly finish, uneven angles, corners not plumb and corners rounded off

Paintwork poor, image shows sticker still on the timber and painted over

Rough tile cuts around doorway

As above

No isolator switch fiited to appliances
No extractor fan fitted

Rough tile cuts around radiator pipes
Signs that the radiator leaks

Lounge door fitted upside down.

Meter cupboard built to a very poor standard,
Sides made up of a number of pieces
Top has been cut incorrectly and two small have been glued inplace to repair
Door hung with the wrong hinges and fitted with no catchs or handles.
In parts need sanding down

Electrical cables left hanging, shoud be chase in the wall or fitted inelectrical ducting

Cables around the consumer unit need to be clipped back to the wall.
Exposed cable should be fitted in a junction box

Door poor fitted, uneven gaps between door and lining.
Paint on door
Door rattles due to thedoor stops not being refitted to suit new door

Rough cut out for latch keep.
Ironmongery does not match

Rough cut out for door inge

Door has been fitted upside down.
The door handle is not parrallel to the door edge
Paint on the door

Rough cut out for latch keep

Architrave are poorly fitted, not all nails have been driven inbelow the surface.
Internal architrave have been fitted the wrong way round

As above

Shower value has been damaged.
Shower supply pipe covers are loose and not siliconed

Stray has not been siliconed

Door loose and has not been silicon.
Width needs adjustment, head is loose and out of level

Poorly applied silicon. Silicon is smugged over the tiles

There are some area of grout are not full or flush

Client informs me the toilet is connected to hot water supply

Rough tile cuts around radiator pipes

Poor decoration generally, some area of the walls appear to have no more then a miscoat applied
Woodwork need an additional sand down and repainted

Upstand to roof light has been left unfinished, no trim or plster stop fitted

Paint and silicon on the head of the bi-fold doors

Head of door opening not level

Bi=fold set too high above the floor

Trickle vent broken

Small section of glass gasket missing

Poor finish around the switch and uneven plaster below

Floor tiling not set out correctly, cut tile ending up in the middle of the pening

Reveals of the kitchen opening out of square

Floor not level, from the kitchento the lounge

Remians of grout left on the floor tiles

Patchy finish to the k-render on the first floor

Damage to k-render behind the downpipe

Render stains on the guttering and fascia

Offset bends missing to the downpipe

K-render has been taken down to ground level, this will now bridge the DPC

Protective film on the bi-fold doors

Exposed cables

End cap to door cill loose

Boundary wall not rendered

Flat roof flashing too low, should be at least 100mm

Top coat of roofing patchy

Old guttering left on the roof